Pim-Sm Configuration Example - 3Com 3032 Configuration Manual

520 C 36: C
HAPTER ONFIGURING
PIM-SM Configuration
Example
PIM-SM
After the above configuration, execute the
display PIM-SM configuration, and to verify the effect of the configuration.
Executethe
debugging
In the actual network, because different manufacturers provide routing
equipment, the routing protocols are different. Because the PIM protocol is
independent of any specific unicast protocol, there is no need to pay attention to
the unicast protocol. The the purpose of this example, the routers are mutually
accessible.
Figure 164 PIM-SM comprehensive configuration networking diagram
Host A
e0
Router A
s 1
1 Configure Router A
a Enable PIM-SM protocol
[RouterA] multicast routing-enable
[RouterA] interface ethernet 0
[RouterA-Ethernet0] pim sm
[RouterA-Ethernet0] interface serial 0
[RouterA-Serial0] pim sm
[RouterA-Serial0] interface serial 1
[RouterA-Serial1] pim sm
b Configure the threshold value of the multicast group switching from the shared
tree to the shortest path tree to be 10kbps.
[RouterA]acl 5
[RouterA-acl-5]rule permit source 225.0.0.0 255.0.0.0
[RouterA-acl-5]pim
[RouterA-pim] spt-switch-threshold 10 accept-policy 5
2 Configure Router B
a Enable PIM-SM protocol
[RouterB] multicast routing-enable
[RouterB] interface serial 0
[RouterB-Serial0] pim sm
[RouterB] interface serial 1
display
command in system view for the debugging of PIM-SM.
s 0
s 0
s 1
s 1
s 0
Router B
s 2
s 0
Router D
command in all views to
Host B
e0
Router C