3Com 3032 Configuration Manual page 724

3com 3032: user guide
Hide thumbs Also See for 3032:
Table of Contents

Advertisement

720
C
51: C
HAPTER
ONFIGURING
DCC
Table 753 Create a Dialer Bundle and Assigning the Physical Interfaces to it
Operation
Add a physical interface to the specified
dialer bundle
Delete the physical interface from the
dialer bundle
By default, no dialer bundle is created, and the physical interfaces do not belong
to any dialer bundle. If a physical interface is assigned to a dialer bundle, a default
priority of 1 is assigned.
Configuring dialing authentication for resource-shared DCC
To implement the resource-shared DCC, the called party must identify the calling
parties through authentication through the communications between the physical
interfaces and the dialer interfaces. Therefore, PAP or CHAP authentication must
be configured.
Use the
dialer user
command in the system view to perform other configuration steps in
password
dial interface (physical or dialer interface) view.
Table 754 Configure Multiple Interfaces to Receive Calls From Multiple Remote Ends
Operation
Configure the remote user name
Delete the remote user name
Configure the link layer protocol to PPP
Configure an authentication mode
Configure the interface to send the local
user name and password for PAP
authentication
Configure the user name that the local
end will send to the remote end for CHAP
authentication
Configure the password that the local end
will send to the remote end for CHAP
authentication
Configure the user name and password
that the remote end is allowed to dial in
The users are recommended to configure either PAP or CHAP authentication on
both the physical and dialer interfaces of both sender and receiver.
When PPP is encapsulated on a Dialer interface, the remote user name gained
through PPP authentication procedure will determine the Dialer interface for
receiving calls, then the command
is optional. While Frame Relay is encapsulated on a Dialer
dialer number
interface, because of no username negotiation procedure, the called end will
distinguish Dialer interfaces according to the received number dialed by calling
end, hence the command
is a must.
number
Command
dialer bundle-member number [
priority priority ]
undo dialer bundle-member number
command in dialer interface view then use the
Command
dialer user username
undo dialer user
link-protocol ppp
ppp authentication-mode { pap | chap
}
ppp pap local-user username password
{ cipher | simple } password
ppp chap user username
ppp chap password { cipher | simple }
password
local-user username password { cipher
| simple } password
dialer user
is optional and the command
dialer user
local-user
is a must and the command
dialer

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

303430333035304030413036 ... Show all

Table of Contents