3Com 3032 Configuration Manual page 21

4 If a dial-up connection is established, then press Enter after the self-test to display
5 Enter command to configure the router or view running status of the router. Enter
Local/Remote Telnet
Connection
Configuration
Environment
1 As shown in the following two figures, connect the Ethernet port adapter on the
Figure 8 Establish a dial-up connection via "HyperTerminal"
Figure 9 Dial on remote computer
the prompt "Username:" and "password:". Enter the correct username and the
password, then enter the system view of Router.
? to get help when necessary. For details of specific commands, please refer to the
following chapters.
After the router powers on, and IP addresses of the interfaces have been properly
configured on the router, you can use the Telnet client program to establish a
connection with the router and log in the router via LAN or WAN. Then configure
the router.
computer with the Ethernet interface of the router. To establish a remote
Establish Configuration Environment 17