Networking Requirements; Networking Diagram; Configuration Procedures - 3Com 3032 Configuration Manual

T ypical Configuration
Example of POS
Access Service
Enable the debugging of POS access interface debugging pos-interface [ pos-id
Configuration Example when the Router is Located at the FEP Side in
TCP/IP Mode
I. Networking Requirements
Three POS terminals access the Router A located at the FEP side through the FCM
card and connect to UNIX A (10.1.1.1) and UNIX B (10.1.1.2) in TCP/IP mode.
II. Networking Diagram
Figure 42 Networking diagram when the router is located at the FEP side in TCP/IP mode
POS
terminal
POS
terminal
POS
terminal
III. Configuration Procedures
1 Enable POS access server
[Router] pos-server enable
2 Configure the POS application to UNIX A in TCP/IP connection mode, the
application is 0.
[Router] pos-server app tcp 0 10.1.1.1 9010
3 Configure the POS application to UNIX B in TCP/IP connection mode, the
application is 1.
[Router] pos-server app tcp 1 10.1.1.2 9020
4 Configure the POS multi-application mapping table (to map the packet whose
destination address is 01f1 to application 0).
[Router] pos-server map 01f1 0
5 Configure the POS multi-application mapping table (to map the packet whose
destination address is 01f2 to application 1).
[Router] pos-server map 01f2 1
6 Configure the Ethernet interface Ethernet 0.
[Router] interface ethernet 0
[Router-Ethernet0] ip address 10.1.1.3 255.255.255.0
7 Configure the POS access interface FCM0
[Router] interface fcm0
[Router-FCM0] async mode pos 1
8 Configure POS access interface FCM1
[Router] interface fcm1
[Router-FCM1] async mode pos 2
Typical Configuration Example of POS Access Service
]
FCM
PSTN
Router
Quidw ay
10.1.1.1/24
UNIX A
E0
10.1.1.3/24
UNIX B
10.1.1.2/24
101