Networking Requirement; Networking Diagram - 3Com 3032 Configuration Manual

Display and Debug X.25
PAD
Typical X.25 PAD
Configuration Example
command can also be nested with the
Exit
access a third or even more routers from a router by repeatedly using the
command or by repeatedly using the
telnet/pad
routers being accessed in turns until returning to the one from which the first call
is placed.
Please implement the following configuration under the system view at the Server
side.
Set the Response Time to the Invite Clear Message
If for some unknown reason (for example, the Client side gives an exit request or
needs to release link resources) after the Server side of the X.25 PAD sends the
link-clearing message Invite Clear to the Client side, the Server side will wait for a
response from the Client side. If the Client side fails to respond to the message
within the specified time, the Server side will clear the link positively.
Please implement the following configuration under the system view at the Server
side.
Table 54 Set the response time to the Invite Clear message
Operation
Set the response time to the Invite Clear message
Perform the following configuration in all views.
Table 55 Display and debug X.25 PAD
Operation
Display the relevant information of X.25 PAD
Enable the debugging of X.25 PAD on varied levels
I. Networking Requirement
As shown in the figure below, with Serial 0 as the interface to the X.25 network,
router A is connected with router B through the X.25 network. It is required that
router B can access and configure router A after it calls router A.
II. Networking Diagram
As shown in Figure 33 "Access remote router through an X.25 PAD".
III. Configuration Procedure
1 Configure RouterA:
a Configure X.25 PAD remote users.
[RouterA]local-user paduser service-type exec-guest password simple
pad
b Enable AAA authentication of X.25 PAD remote users.
[RouterA] login pad
X.25 PAD Remote Access Service
command. That is, users can
Pad
command to exit the
exit
Command
x29 inviteclear-time time
seconds
Command
display x25 pad [
pad-number ] [ tty ]
debugging pad { packet |
error | all }
71