3Com 3032 Configuration Manual page 140

136 C 10: C
HAPTER ONFIGURING
WAN I
NTERFACE
Bind the interface to be a pri set
Set the length/attenuation of the transmission cable
Set the line code format
Set line clock
Set frame format
Enable/disable internal loopback/external loopback
1 Enter the view for a specified interface
In system view, use the following command to enter the view of a specified
CT1/PRI interface.
Table 137 Enter the view of a specified interface
Operation
Enter the view of CT1/PRI interface
2 Bind the interface to be channel sets
Perform the following configurations in CT1/PRI interface view.
Table 138 Bind the interface to be channel sets
Operation
Bind the timeslots of CT1/PRI interface to a
channel set
Remove binding timeslots to form channel
sets
The timeslots can be bind to form up to 24 on a CT1/PRI interface.
The CE1/PRI interface can be bound to be channel sets only when it is enabled to
operate in CE1/PRI mode through the using ce1 command.
Only one timeslot binding mode is supported on one CT1/PRI interface at one
time, that is, the interface can only be bound into either channel sets or a pri set in
that period.
After binding the interface to be channel sets, the system will automatically create
a Serial interface numbered serial number:set-number. This interface has the
same logic feature as that of a synchronous serial interface, and can be treated as
a synchronous serial interface for further configurations.
Perform the following configuration in all views.
Table 139 Enter the synchronous serial interface view
Operation
Enter the synchronous serial interface view
The following is to be set:
Operating parameters of data link layer protocol, such as PPP, Frame Relay,
LAPB or X.25.
IP address
The operating parameters of the standby center need to be set when the
interface serves as the main interface or standby interface of the standby
center.
Command
controller t1 number
Command
channel-set set-number
timeslot-list range [ speed { 56 |
64 } ]
undo channel-set set-number
Command
interface serial
number:set-number