3Com 3032 Configuration Manual page 27

View name Function
X.25 hunt Configures the X.25
group view hunt group parameters
Frame Relay Configures the FR class
class view parameters
DLCI view Configures the DLCI
parameters
Frame Relay Configures the FR
switch view switch parameters
MFR interface Configures the MFR
view interface parameters
L2TP group Configures L2TP group [Router-l2tp1]
view
IPSec proposal Configures a security
view proposal
IPSec policy Configures a security
view policy
IKE proposal Configures an IKE
view proposal
ACL view Configures ACL rules
DHCP address Configures a DHCP
pool view address pool
Command Line
Online Help
Prompt
[Router-X25-huntgroup-abc]
[Router-fr-class-abc]
[Router-fr-dlci-100]
[Router-fr-switch-abc]
[Router-MFR0]
[Router-ipsec-proposal-abc]
[Router-ipsec-policy-abc-0]
[Router-ike-proposal-0]
[Router-acl-1]
[Router-dhcpabc]
The command line prompt character consists of the network device name (Router
by default) and the command view name, such as [Router-rip].
The commands are divided according to view. In general, in a certain view, only
the commands defined by the view can be executed, but some widely used
commands (including
ping
, and
logic-channel controller
For some views listed in the above table, you must enable the corresponding
functions before you can enter the views. To enter some other views, however,
you should configure the related restriction conditions. For more information, see
the related chapters in this manual.
In all views, you can use the
and the command to the system view directly.
return
The command line interface of the 3Com Router provides the following online
helps:
Full help
Partial help
Command Line Interface (CLI)
Enter command
Enter x25
hunt-group abc
round-robin in
system view
Enter fr class
abc in system view
Enter fr dlci 100
in synchronous serial
interface view. (The
link layer protocol
encapsulated on the
interface should be
FR.
Enter fr switch
abc in system view
Enter interface
mfr 0 in any views
Enter l2tp-group
1 in system view
Enter ipsec
proposal abc in
system view
Enter ipsec
policy abc 0 in
system view
Enter ike
proposal 0 in
system view
Enter acl 1 in
system view
Enter dhcp server
ip-pool abc in
system view
, , ,
display debugging
) can be executed in all views
command to return to the superior-level views,
quit
Exit command
Enter quit to return
to the system view
Enter quit to return
to the system view
Enter quit to return
to the synchronous
serial interface view
Enter quit to return
to the system view
Enter quit to return
to the system view
Enter quit to return
to the system view
Enter quit to return
to the system view
Enter quit to return
to the system view
Enter quit to return
to the system view
Enter quit to return
to the system view
Enter quit to return
to the system view
, ,
reset save interface
23
,