Installing Expansion Modules - Omron CX-INTEGRATOR V2 - 12-2009 Operation Manual

7-8-2

Installing Expansion Modules

When a new model of CompoNet Unit is released, the new component can be used by
installing an expansion module for the CX-Integrator that supports the new component.
There are two methods to install expansion modules depending on the format of the
information file for the new component.
• DTM installation
• EDS file installation
Note: The DTM (Device Type Manager) is add-in software that uses FDT/DTM technology,
Note: When using Windows Vista or Windows 7, refer to Appendix 3. It provides
For information on how to obtain expansion modules, refer to the applicable Unit
manual.
Installing the DTM
The DTM software is used to install component information to the CX-Integrator. Use
the following procedure to install the DTM.
1. Start the DTM Installer.
2. Follow the instructions in the dialog box that is displayed to continue the
3. Start the CX-Integrator. If the CX-Integrator is already running, select Update
EDS File Installation
An EDS file contains the new component information. Use the following procedure to
install the EDS file.
1. Select Tools – EDS file – Install EDS.
2. Select the EDS file provided by the vendor of the new Unit.
3. Click the Open Button. The EDS file will be installed.
an open standard for field networks.
precautions when installing Expansion Modules.
installation.
DTM Catalog from the Tools Menu.
Installation complete.
The new component is displayed on the DTM (CompoNet) Tab Page component
list.
After the installation has been completed, the new component will be displayed
in the tree of the component list on the DTM (CompoNet) Tab Page.
7-8 Other CompoNet Functions
7-8-2 Installing Expansion Modules
7-31