Editing Master Unit Parameters; Master Unit Parameter Settings - Omron CX-INTEGRATOR V2 - 12-2009 Operation Manual

7-6 Editing Master Unit Parameters

7-6-1 Master Unit Parameter Settings

7-6 Editing Master Unit Parameters
Edit Master Unit parameter settings as needed. For details on Unit parameter settings,
refer to the Unit manual.
This section describes the setting parameters for an OMRON CompoNet Master Unit.
7-6-1 Master Unit Parameter Settings
The settable Master Unit parameters are listed in the following table.
General
Registration Table
(See note.)
Software Setting
Table (See note.)
Note: Displayed only when Registration Table and Software Setting Table are enabled on
Parameter Setting Procedure
1. Connect online to the actual CompoNet Network, and upload the network
2. From the Network Configuration Window, double-click the Master Unit, or right
The Master Unit Parameter Settings Dialog Box will be displayed.
The contents of each tab page are shown next. For details on parameter settings, refer
to the Master Unit manual.
7-18
Tab page
Function Choice
Registration Table
Software Setting Table
Transfer/Compare
Unregistered/
Registered Device List
Advanced Setting
Data
Participation
Flag/Communications Error
Flag
the General Tab Page.
configuration to the computer. Alternatively, the network configuration can be
read from a CX-Integrator project file.
click it and select Parameter - Edit from the menu. (Alternatively, select
Parameter - Edit from the Component Menu.)
Double-click, or right-click and select
Parameter – Edit.
Setting
Sets communications settings.
Displays the Registration Table Tab
Page.
Displays the Software Setting Table Tab
Page.
Performs uploading, downloading, and
comparison of parameters between the
computer and components.
Sets the Slave Units that will join the
network.
Sets the conditions for the Slave Units
that will join the network.
User-defined areas can be allocated to
the Slave Units and error flags.
Description