Omron CX-INTEGRATOR V2 - 12-2009 Operation Manual page 24

3 Application Precautions
xxiv
• If incorrect data link tables or parameters are set, injury may result due to
unexpected operation of the system. Even if the correct data link tables and
parameters have been set, do not start or stop data links before verifying
that there will be no adverse influence on the system.
Routing Tables
CPU Bus Units are reset when routing tables are transferred from a
Programming Device to a PLC to allow set routing tables to be read. Make
sure that resetting CPU Bus Units will not cause equipment damage or
dangerous system behavior before transferring tables.
CompoNet
• Be sure to start operation only after transferring the necessary parameters in
the EEPROM of the CompoNet Master Unit (e.g., software settings and
registration table settings) from the CX-Integrator to the CompoNet Master
Unit.
• I/O allocations may change if the communications mode of the CompoNet
Master Unit is changed.