Omron CX-INTEGRATOR V2 - 12-2009 Operation Manual page 351

5. Select the Edit the Registration Table Check Box on the General Tab Page.
The Registration Table Tab Page will be displayed.
6. Set the memory area, first address, and number of nodes for each area.
The start location is specified by setting the CPU Unit memory area and the
address of the first word. The number of nodes to which to allocate words is
specified to give the size of the area.
CPU Unit
Area memory
area
Word OUT CIO, DM,
WR, or HR
Word IN
Area
Bit OUT
Bit IN
The allocated start location for the status is as follows:
Participation and
Communications
Error Flags
Word Slave Status CIO, DM,
WR, or HR
Area
Bit Slave Status
7. Click the Apply Button. The settings will be saved.
8. Click the Transfer [PC to Unit] Button on the General Tab Page for the Master
Unit. The settings will be downloaded to the Master Unit.
7-6 Editing Master Unit Parameters
7-6-3 Editing the Software Setting Table
Address
(allocated start address
for each area)
User-set address. Set for
each area.
CPU Unit Address
memory (allocated start address
area for each area)
User-set address. Set for
each area.
Number of nodes
(number of node addresses to
which to allocate memory)
64 max.
64 max.
128 max.
128 max.
Allocated contents
Word slave status
(1 word), Setting
parameter (1 word),
Participation Flags, and
Communications Error
Flags (16 words)
Bit Slave Participation
Flags and
Communications Error
Flags (32 words)
7-27