Omron CX-INTEGRATOR V2 - 12-2009 Operation Manual page 45

Note Connecting the PLC Using a USB Port on the Computer
A USB port on the computer can be used to connect the computer running the
CX-Integrator to a CS/CJ-series PLC. To do so, connect the computer to the PLC as
shown below using a CS1W-CIF31 USB-Serial Conversion Cable.
The driver software included with the CJ1W-CIF31 must be installed on the computer
to use a USB port to connect the CX-Integrator. Refer to the PDF User's Manual
included with the CS1W-CIF31 USB-Serial Conversion Cable for details.
When connecting the computer to a CP-series PLC, it is possible to make a direct
connection using a commercially available USB cable (B type – A type connectors).
PLC Connection Methods
Computer
running CS1W-CIF31
CX-Integrator
CS1W-CIF31
USB Connecting Cable
CS/CJ-series CPU Unit Connection Patterns
USB
Connecting
Cable
Model Connector
CS1W-CIF31 D-sub 9-pin CS1W-CN226/626
female (length: 2 m/6 m)
D-sub 9-pin CQM1-CIF02
female (length: 3.3 m)
D-sub 9-pin XW2Z-200S-CV
female /500S-CV
(length: 2 m/5 m)
D-sub 9-pin XW2Z-200S-V
female /500S-V
(length: 2 m/5 m)
D-sub 9-pin XW2Z-200S-CV
female /500S-CV
(length: 2 m/5 m)
D-sub 9-pin XW2Z-200S-V
female /500S-V
(length: 2 m/5 m)
Cable 1
CS1W-N226/626 CS/CJ-series
Peripheral Port Programming
Device Connecting Cable
or
CQM1H-CIF02 C-series
Peripheral Port Programming
+
Device Connecting Cable
or
XW2Z-@@@ RS-232C Programming
Device Connecting Cable
Cable 1
Model Connector Connector
CS/CJ
peripheral
C peripheral C peripheral
D-sub 9-pin D-sub 9-pin
male female
D-sub 9-pin D-sub 9-pin
male female
RS-232C
D-sub 9-pin
male
RS-232C
D-sub 9-pin
male
1-4 PLC Connecting Cables
1-4-1 Direct Serial Connections to a PLC
Cable 2
(when required)
CS1W-CN114
C-series-CS/CJ-series
Peripheral Conversion Cable
+
CS1W-CN118
RS-232C-CS/CJ-series
Peripheral Conversion Cable
Cable 2
Model Connector
Not needed.
CS1W-CN114 CS/CJ
(length: 5 cm) peripheral
CS1W-CN118 CS/CJ
(length: 0.1 m) peripheral
CS1W-CN118 CS/CJ
(length: 0.1 m) peripheral
Not needed.
Not needed.
PLC
Port Serial
communications
mode
(network
type)
CS/CJ Peripheral
peripheral (Toolbus)
or Host Link
(SYSWAY)
Host Link
(SYSWAY)
Peripheral
(Toolbus)
or Host Link
(SYSWAY)
Host Link
(SYSWAY)
RS-232C Peripheral
D-sub 9-pin (Toolbus)
female or Host Link
(SYSWAY)
Host Link
(SYSWAY)
1-17