Omron CX-INTEGRATOR V2 - 12-2009 Operation Manual page 322

6-15 Using General-purpose Tools to Set Devices
6-15-1 Setting Device Parameters with Class Instances
4. Designate the service.
There are two ways to designate the service code, using the generic service code
defined by DeviceNet or designating it directly. To use the generic service code
defined by DeviceNet, check the Generic option, then 4. Select the desired service
from the drop-down list. To designate the service code directly, check the Custom
option, then input the service code in a HEX format string.
5. Designate the class and instance parameters for reading and writing data.
6. Input the data corresponding to the designated service.
7. After all of the items have been input, click the Send Button. The device response
will be displayed in the Result area.
8. Click the Close Button to quit device parameter setting. This completes the device
parameter setting.
1. Parameter Reading Example
1) Check the Generic option in Service, then select Get Attribute Single from the
2) Designate the class and instance of the parameter to be read.
3) Input Data Area for the Attribute of the parameter to be read.
4) Click the Send Button. The value that was read will be displayed in the Result
2. Parameter Setting Example
1) Check the Generic option in Service, then select Set Attribute Single from the
2) Designate the class and instance of the parameter to be set.
3) Input Data Area for the Attribute of the parameter to be set.
4) Input the attribute followed by the value to be set for the parameter in the Data
5) Click the Send Button.
6-70
Designating the Generic Service Code
Defined by DeviceNet
drop-down list.
area.
drop-down list.
area.
Designating the Service Code Directly