Omron CX-INTEGRATOR V2 - 12-2009 Operation Manual page 232

4-3 Manually Setting Data Links
4-3-11 Transferring the Data Link Table
4. Click the Yes Button.
A message will appear to tell you if there are any differences between the two sets
of data link table.
5. If differences are found and the OK Button is clicked, the Verification Result Dialog
Box will be displayed.
Select the node address to display the data link area data for both the PLC and in
the computer for the specified node address: Area 1 Size, Area 1 Offset, Area 2
Size, and Area 2 Offset. The size of this dialog box can be changed.
The data for the PLC is display on top and that for the computer (i.e., the data being
edited on the CX-Integrator) is displayed on bottom. Inconsistencies are displayed
between pointed brackets < >.
Click the Copy Button to place a copy of the verification results on the clipboard for
use in other programs, e.g., text editors, as shown below.
4-40