Omron CX-INTEGRATOR V2 - 12-2009 Operation Manual page 44

1-4 PLC Connecting Cables
1-4-1 Direct Serial Connections to a PLC
Unit Unit port
CPU Unit Built-in
peripheral port
Connection to
RS-232C Port
Note The following connection methods can be used when connecting an CQM1-CIF01/02
cable to a peripheral port on a CS/CJ-series PLC.
Unit Unit port
CPU Unit Built-in peripheral
port
Connection to
RS-232C Port
1-16
Computer
Computer
port
IBM D-sub 9-pin
PC/AT or male
compatible
IBM D-sub 9-pin
PC/AT or male
compatible
XW2Z-@@@S-@@
RS-232C cable
(listed above)
CS1W-CN118
Peripheral port
Computer
Computer
port
IBM D-sub 9-pin
PC/AT or male
compatible
CQM1-CIF01/02
Peripheral Cable
Network type
(serial
communications
mode)
Peripheral bus CS1W-CN118 +
(Toolbus) XW2Z-200S-CV/
or Host Link 500S-CV
(SYSWAY)
Host Link CS1W-CN118 +
(SYSWAY) XW2Z-200S-V/
500S-V
Network type
(serial
communications
mode)
Host Link CS1W-CN114 +
(SYSWAY) CQM1-CIF02
Note: Baud rate
must be 19.2
Kbits/s or less.
CS1W-CN114
Peripheral port
Model Length Remarks
0.1 m + The
2 m/5 m XW2Z-@@@
S-CV uses a
connector
with ESD
(electrostatic
discharge)
counter-
measures.
0.1 m + ---
2 m/5 m
Model Length Remarks
0.05 m + ---
3.3 m