Editing The Registration Table - Omron CX-INTEGRATOR V2 - 12-2009 Operation Manual

7-6-2

Editing the Registration Table

The Registration Table sets the relationship between the node addresses and Slave
Units. The Registration Table is used in the following cases.
• When comparing the Slave Units that are participating in the network and the Slave
• When an unregistered Slave Unit or a Slave Unit with a different node address or
Edit the Registration Table using CX-Integrator, and download it to the Master Unit.
1. Turn ON the REGS (Registration Table Enable Setting) switch on the front of the
2. Turn ON the power to the CompoNet Unit and computer.
3. Start the CX-Integrator and connect online.
4. Right-click the Master Unit Icon in the Network Configuration Window and
Units that have been set up.
model must not be permitted to participate in the network.
CX-Integrator
Edit and download the Registration Table.
Registration Table
Node Model
0 ID16
1 OD16
: :
Upload (with other Master parameters).
Master Unit.
select Parameter - Edit. The Master Unit's Parameter Dialog Box will be
displayed.
7-6 Editing Master Unit Parameters
7-6-2 Editing the Registration Table
Edit Registration Table
CompoNet Master Unit
SW4 (REGS SW) is ON
CS/CJ-series PLC
Node address and slave
relationship registered
according to actual network
configuration
CompoNet
Word Slaves
Bit Slaves
7-23