Jog - Siemens SINAMICS G220 Operating Instructions Manual

Functions
14.9 Setpoint channel
14.9.12

Jog

Overview
The Jog function is typically used to temporarily move a motor using local control commands.
Description of function
Figure 14-76
Commands "Jog 1" and "Jog 2" switch the motor on and off.
Figure 14-77
After switch-on, the motor accelerates to setpoint Jog 1 or Jog 2. The two different setpoints
can be assigned to clockwise and counter-clockwise rotation of the motor, for example.
When jogging, the same ramp-function generator is active as for the ON/OFF1 command.
Parameters
The following list contains the parameters of the "Jog" function.
Number
c1055[0...n]
c1056[0...n]
p1058[0...n]
p1059[0...n]
p1082[0...n]
c1110[0...n]
462
Jog
Behavior of the motor when jogging
Name
Jog bit 0
Jog bit 1
Jog 1 speed setpoint
Jog 2 speed setpoint
Maximum speed
Inhibit negative direction
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB
Unit
[rpm]
[rpm]
[rpm]
SINAMICS G220 converter