Dynamic Drive Control Operating Mode; Differences Between Speed Control And Dynamic Drive Control; Setting Of Technological Application In Dynamic Drive Control - Siemens SINAMICS G220 Operating Instructions Manual

14.10.3

Dynamic Drive Control operating mode

14.10.3.1

Differences between speed control and Dynamic Drive Control

Overview
Selecting the Dynamic Drive Control operating mode in quick setup simplifies the structure of
the speed control, which reduces the setting options.
Requirement
Dynamic Drive Control works with the following motors:
• Induction motor
• Synchronous motor without starting cage
• Reluctance motor without starting cage
Description of function
Setting options with and without selection of the Dynamic Drive Control operating modes:
Closed-loop torque control
without higher-level speed
controller
Droop
K - and T
P
Hold or set the integral com‐
ponent of the speed control‐
ler
Acceleration model for pre‐
control
Motor data identification at
standstill or with rotating
measurement
14.10.3.2

Setting of technological application in Dynamic Drive Control

Overview
The selected technological application optimizes the calculation of the open-loop and closed-
loop control parameters in Dynamic Drive Control operating mode.
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB
Speed control after selection of the
Dynamic Drive Control operating
adaptation
I
Shortened, with optional transition into
14.10 Closed-loop drive control
mode
Not possible
Not possible
Simplified
Not possible
Default setting
operation
Functions
Speed control without select‐
ing an operating mode
Possible
Possible
Advanced
Possible
Can be activated
Complete
473