7.1.4.2
Access to the power connections up to frame size FSC
Precondition
The housing cover has been removed.
Tool required: Torx screwdriver T20
Procedure
Proceed as follows to access the converter power connections up to frame size FSC:
Figure 7-6
1. Release the two screws marked in the diagram.
2. Slide the sheet metal plate marked in the diagram upwards until the lower side of the sheet-
metal edge engages with the catch.
Proceed as follows after connecting the power cables:
Figure 7-7
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB
Establishing access to the power connections
Sliding down the sheet metal plate and tightening the screws
7.1 Line system, motor and braking resistor
Connecting
159