When Using The A/D Conversion Function - Mitsubishi Electric NZ2GN2S-D41P01 User Manual

14.4

When Using the A/D Conversion Function

This section describes the function to A/D convert the analog value input to External input signal CH0 (E0) and monitor the
value with the CPU device.
FPGA parameter
The setting values of the FPGA parameters to be set are shown below.
Setting item
Data sampling timing (E0)
A/D conversion enable/disable setting (E0)
Select A/D conversion timing (E0)
ADC range setting CH0 (E0)
ADC oversampling ratio setting (E0)
ADC offset value CH0 (E0)
User circuit part parameter
The setting value of the user circuit part parameter to be set is shown below.
Address

Setting method
The procedure using the FPGA Module Configuration Tool is shown below.
Operating procedure
1.
Create the project with the following settings.
Set NZ2GN2S-D41P01 as the connected main module and NZ2EX2S-D41A01 as the connection extension module.
[Project]  [New]
2.
Click the [OK] button.
3.
Enter the IP address of the FPGA module to be connected in the "Connection destination setting" window.
[Menu]  [Connection destination setting]
4.
Click the [Communication Test] button.
5.
Click the [OK] button.
6.
Click the [Apply] button.
14 SAMPLE CIRCUIT IN CC-LINK IE TSN COMMUNICATION MODE
408
14.4 When Using the A/D Conversion Function
Setting value
4s
Conversion-enable
Data sampling timing
-9.9 to 9.9V
No setting
0
Setting item
User circuit part parameter size
Setting value
384