When Using The D/A Conversion Function - Mitsubishi Electric NZ2GN2S-D41P01 User Manual

13.3

When Using the D/A Conversion Function

This section describes the function to D/A-convert a digital value and output a voltage in CH0 (E0).
System configuration example
FPGA Module
Configuration Tool
FPGA module: NZ2GN2S-D41P01+NZ2EX2S-D41A01
Module parameter
The setting value of the module parameter is shown below.
Setting item
FPGA control automatic start setting
FPGA parameter
The setting values of the FPGA parameters to be used are shown below.
Setting item
D/A conversion enable/disable setting CH0 (E0)
Select D/A conversion value CH0 (E0)
Select D/A conversion timing (E0)
Select DAC LDAC signal (E0)
DAC offset value CH0 (E0)
DAC range setting CH0 (E0)
User circuit part parameter
The setting values of the user circuit part parameters to be set are shown below.
Address

1000_B2C0H (writing data 352)
13 SAMPLE CIRCUIT IN STANDALONE MODE
376
13.3 When Using the D/A Conversion Function
FPGA module
Setting item
User circuit part parameter size
Analog output part LDAC output selection (usr_wreg_160)
Voltage output
(-9.9 to 9.9V)
Setting value
Enable
Setting value
Conversion-enable
User circuit output
User circuit output
User circuit output
0
-9.9 to 9.9V
Setting value
384
0001H