Performance Specifications; Common To The Modules - Mitsubishi Electric NZ2GN2S-D41P01 User Manual

5.2

Performance Specifications

Common to the modules

Item
Station type
CC-Link IE TSN Class
Network topology
CC-Link IE TSN Protocol version
Cyclic RX/RY points
transmission
RWr/RWw points
Maximum response time for time-managed polling (for CC-
Link IE TSN Class A)
Multicast filter
FTP transfer FTP server software for operation check
(client)
Number of settable transfer destinations
Communication speed
Communication 1Gbps
cable
100Mbps
Insulated area
Withstand voltage
Insulation resistance
*2
Noise immunity
Protection degree
External Communication part
interface
Module power supply part
I/O part
Applicable wire For module power supply
size
For I/O
Applicable Terminal block for module power supply
solderless and FG
terminal
I/O terminal block
*4
External power supply
Incorporated Device name
FPGA
Circuit capacity
Available capacity for user (recommended value)
FPGA system clock
*1 When a solderless terminal with an insulation sleeve is used, the applicable wire size is 0.75 or smaller.
*2 It is the noise immunity of when the set filter value is equal to or more than the recommended value. Note that the module is easily
affected by noise if a value less than the recommended value is set. The recommended value depends on the input used (24VDC input,
differential (RS-422) input, or differential (RS-485) input). For details, refer to the following.
Page 196 Digital input control part (di2_top)
*3 If a timing violation occurs due to the logic synthesis, correct the user circuit.
*4 For the external power supply, use a SELV (Safety Extra Low Voltage) power supply that meets LIM (Limited Energy Circuit) or UL 1310
Class 2.
Specifications
Remote station
CC-Link IE TSN Class B/A
Line topology, star topology, mixture of star topology and line topology, ring topology
CC-Link IE TSN Class B: ver.1.0/2.0, CC-Link IE TSN Class A: ver.2.0
112 points
144 points
2048s
Available ( Page 133 Communication mode)
Microsoft IIS
1 maximum
1Gbps
100Mbps
Ethernet cable (Category 5e or higher, straight cable)
Ethernet cable (Category 5 or higher, straight cable)
Between power supply system and I/O part: Insulation
Between communication system and I/O part: Insulation
Between terminal blocks of I/O part: Insulation
Between channels of I/O part: Non-insulation
Between power supply system and I/O part: 500VDC for 1 minute
Between communication system and I/O part: 500VDC for 1 minute
Between ground and I/O part: 500VDC for 1 minute
Between power supply system and I/O part: 10M or higher (500VDC insulation resistance
tester)
Between communication system and I/O part: 10M or higher (500VDC insulation resistance
tester)
Between ground and I/O part: 10M or higher (500VDC insulation resistance tester)
Noise voltage 500Vp-p, noise width 1s, noise frequency 25 to 60Hz (noise simulator condition)
IP2X
RJ45 connector
Spring clamp terminal block
Spring clamp terminal block
Stranded wire: 0.3 to 1.5 (22 to 16 AWG),
terminal slot size: 2.4mm  1.5mm
Stranded wire: 0.3 to 1.5 (22 to 16 AWG)
Page 66 Applicable solderless terminals
Page 70 Applicable solderless terminals
24VDC (Allowable voltage range: 20.4 to 28.8VDC, ripple rate: 5% or less)
Current consumption: Total current consumption of main module and extension module (
Page 34 Main module, Page 41 Extension module)
5CGXFC7D6F27I7N (Cyclone
LUTs = 149.5K (650K gates), block RAM = 7000K bits
*3
LUTs = 35K (150K gates), block RAM = 4400K bits
100MHz
*1
 
V series manufactured by Intel )
5 SPECIFICATIONS
5.2 Performance Specifications
5
33