Setting The Function Setting Switches - Mitsubishi Electric NZ2GN2S-D41P01 User Manual

Setting the function setting switches

Set the following functions using the DIP switch on the front of FPGA module.
• Operation mode setting function
• CC-Link IE TSN Class setting function
• Communication speed setting function
• Lock function of FPGA download via Ethernet
• JTAG FPGA download error detection disable function
• I/O signal indication setting function
• Always write register write function
When operating the function setting switch, use a flathead screwdriver with a tip width of 1.2mm or less.
Setting method
Set each function with the function setting switch 1 to function setting switch 10.
Switch name
Function setting
switch 1
Function setting
switch 2
Function setting
switch 3
Function setting
switch 4
Function setting
switch 5
Function setting
switch 6
7 INSTALLATION AND WIRING
58
7.1 Setting Switches
Function name
MODE Operation mode setting
function
CCIETSN Class CC-Link IE TSN Class
setting function
LINK SPEED Communication speed
setting function
ETHERNET Lock function of FPGA
LOCK download via Ethernet
JTAG JTAG FPGA download
error detection disable
function
T-LED SHIFT I/O signal indication
setting function
Setting details
Sets the FPGA module operation mode.
• OFF: CC-Link IE TSN communication mode
• ON: Stand-alone mode
Sets CC-Link IE TSN Class.
• OFF: CC-Link IE TSN Class B
• ON: CC-Link IE TSN Class A
By using the function setting switch 1 and the IP address/station number setting
switch together, the IP address can be initialized in unit test mode or stand-alone
mode. ( Page 57 Initializing IP address in stand-alone mode, Page 432 MODULE
DIAGNOSTICS WITH THE FPGA MODULE CONFIGURATION TOOL)
For the CC-Link IE TSN Class setting status, refer to the following.
Page 495 Function setting switch state monitor
Sets the communication speed.
• OFF: 1Gbps
• ON: 100Mbps
For the communication speed setting status, refer to the following.
Page 495 Function setting switch state monitor
Prohibits FPGA download via Ethernet.
• OFF: Enable
• ON: Prohibit (lock)
For details on the FPGA download function, refer to the following.
Page 300 FPGA Download Function
Turn on the switch when performing the FPGA download via JTAG.
Be sure to turn off the switch after the completion of the download.
• OFF: Error detection enabled
• ON: Error detection disabled
For details on the FPGA download function, refer to the following.
Page 300 FPGA Download Function
Sets the terminal block whose I/O status is to be displayed on the TERMINAL NO.
• OFF: Fix LED indication terminal block.
• ON: Change LED indication terminal block. (The LED corresponding to each
terminal block alternately lights up in every two seconds)
For details on the I/O status indicator LED setting, refer to the following.
Page 31 TERMINAL NO. LEDs setting method