Eaton Powerware BladeUPS User Manual page 59

3. Remove the six screws on the conduit landing plate and retain. Remove the plate
and retain. See Figure 33.
Bottom Entry Rack
Figure 33. Removing the Conduit Landing Plate
4. Use a Greenlee punch to provide one or more holes in the conduit landing plate
to accommodate the input and output wiring from the utility to the
BladeUPS Bar.
Replace the conduit landing plate.
5. Connect the input, output, and ground wires to the BladeUPS Bar terminal block
according to Figure 34 and Table 6. Route the three input phases and the input
neutral through the mounted or loosened ferrite assembly (see Figure 32).
Ground
Bottom Entry Terminal Block
Figure 34. BladeUPS Bar Terminal Block
Eaton BladeUPS (12 kVA) User's Guide
STANDARD SYSTEM INSTALLATION
Top Entry Terminal Block
S
164201649 Rev 6 www.eaton.com/powerqualtiy
Top Entry Rack
Ground
51