STANDARD SYSTEM INSTALLATION
50
Eaton BladeUPS (12 kVA) User's Guide
To install the parallel system input and output wiring:
1.
Remove the five screws on the wireway access cover and retain. Remove the
cover and retain. See Figure 31.
Figure 31. Removing the Wireway Access Cover (Bottom Entry Rack Shown)
2.
Bottom Entry Wiring only. Remove the eight screws on the wireway top cover and
retain. Slide the cover back and off the wireway and retain. See Figure 32.
Wireway Top
Cover
Ferrite Assembly
(mounted)
S
164201649 Rev 6 www.eaton.com/powerqualtiy
Figure 32. Removing the Wireway Top Cover