Eaton Powerware BladeUPS User Manual page 40

PREASSEMBLED SYSTEM INSTALLATION
32
Eaton BladeUPS (12 kVA) User's Guide
5. Reinstall the battery cover plate.
6. Install the UPS front cover (see Figure 18):
Plug the LCD cable from the control panel on the front cover into the connector
on the electronics module. Use care to loop the LCD cable gently in front of the
electronics module.
Push the top of the front cover firmly into place, and then push the bottom firmly
into place.
7. For six UPS preassembled systems only. Repeat Steps 1 through 6 for UPS 6.
8. If installing optional EBM(s), continue to the following section, "EBM Setup."
Otherwise, continue to "Parallel System Initial Startup" on page 42.
S
164201649 Rev 6 www.eaton.com/powerqualtiy
Figure 17. Installing the UPS Battery Trays
LCD Cable
Figure 18. Installing the UPS Front Cover