Eaton Powerware BladeUPS User Manual page 35

To install the parallel system input and output wiring:
1. Verify that all battery circuit breakers on all UPSs are in the OFF (O) position (see
Figure 10).
2. Remove the five screws on the wireway access cover and retain. Remove the
cover and retain. See Figure 11.
Figure 11. Removing the Wireway Access Cover (Bottom Entry Rack Shown)
Eaton BladeUPS (12 kVA) User's Guide
PREASSEMBLED SYSTEM INSTALLATION
Load
Connector
Input
Breaker
Breaker
Figure 10. BladeUPS Module Rear Panel
S
164201649 Rev 6 www.eaton.com/powerqualtiy
Battery
Breaker
27