The BladeUPS Bar for parallel systems, mounted in the rear of an Eaton rack, provides
the required input and output connections for the paralleled UPSs and has a single
system-rated input connection. Figure 2 shows an example of a BladeUPS parallel
system.
The BladeUPS system can be installed with Eaton remote power panels and
rack-mounted power distribution systems.
BladeUPS Bar
Bottom Entry
Wireway
Figure 2. Example of a BladeUPS Parallel System
Note the following guidelines when configuring your BladeUPS standalone module or
parallel system:
S
The UPS accommodates a maximum of four EBMs.
S
The EBM(s) for a standalone UPS can be mounted directly below the UPS or, with
rack side panels removed, in an adjacent rack to the left of the rack containing the
UPS.
S
The EBMs for a parallel system can be mounted in an adjacent rack to the left of
the rack containing the UPS (rack side panels removed).
Eaton BladeUPS (12 kVA) User's Guide
S
164201649 Rev 6 www.eaton.com/powerqualtiy
INTRODUCTION
BladeUPS Module
BladeUPS Module
BladeUPS Module
3