Eaton Powerware BladeUPS User Manual page 33

3. Verify that the following items are in the accessory box:
S
UPS documentation and software tools:
- Software Suite CD
- BladeUPS: Documents, Firmware, and Installation Video CD
- This user's guide
S
(2) door keys
S
CAN Bridge Card accessories:
- (1) CAN Bridge Card cable
- (1) Redundant Signal cable
S
Optional X-Slot card accessories
The preassembled system can be ordered with any of the optional X-Slot
cards installed. Accessories for installed cards are in the accessory box.
Table 3 lists the cards and the associated accessories.
Table 3. Optional X-Slot Card Accessories
Optional Card
®
ConnectUPS -X Web/SNMP Card
Relay Interface Card
Modbus Card
®
Industrial Relay Card
Power Xpert Gateway Series 2000 Card
®
4. Verify that the supplied keys lock and unlock the door.
5. Optional. You may flip the rack door to allow it to open from the opposite side. To
flip the door:
Remove the hinge pins, then remove the door. Move the hinges to the opposite
side of the rack. Reorient the door and hang it on the hinges; replace the hinge
pins.
Reverse the door handle mounting.
NOTE The handle uses gravity to operate properly. Reversing the handle is required.
Move the Eaton logo to the upper part of the door.
6. Verify that the leveling feet are long enough to lower to the floor.
7. Continue to the following section, "Installing the Input and Output Wiring."
Eaton BladeUPS (12 kVA) User's Guide
PREASSEMBLED SYSTEM INSTALLATION
Documentation
User's guide
—
User's guide
User's guide
User's guide
Reminder card
S
164201649 Rev 6 www.eaton.com/powerqualtiy
Other Accessories
Serial cable
Ethernet cable
Small mounting plate
(2) screws
Serial cable
Metal plate
(2) screws
Serial cable
Ethernet cable
25