Eaton Powerware BladeUPS User Manual page 39

2. Remove the UPS front cover and set it aside (see Figure 15).
Grasp the fingergrips on both sides of the cover and pull the cover forward
firmly. Unplug the LCD cable connecting the back of the control panel to the
electronics module.
LCD
Cable
3. Remove the eight screws on the battery cover plate and retain. Remove the
plate and retain. See Figure 16.
Figure 16. Removing the UPS Battery Cover Plate
4. Slide the battery trays into the cabinet (see Figure 17). Verify that each tray is
properly aligned before sliding the tray in.
When a tray is fully installed, tuck the plastic handle on the end of the tray into
place.
Eaton BladeUPS (12 kVA) User's Guide
PREASSEMBLED SYSTEM INSTALLATION
Figure 15. Removing the UPS Front Cover
S
164201649 Rev 6 www.eaton.com/powerqualtiy
31