Eaton Powerware BladeUPS User Manual page 2

Class A EMC Statements
FCC Part 15
NOTE This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in
which case the user will be required to correct the interference at his own expense.
ICES-003
This Class A Interference Causing Equipment meets all requirements of the Canadian Interference Causing Equipment Regulations ICES‐003.
Cet appareil numérique de la classe A respecte toutes les exigences du Reglement sur le matériel brouilleur du Canada.
EN 62040-2
Some configurations are classified under EN 62040-2 as "Class‐A UPS for Unrestricted Sales Distribution." For these configurations, the following
applies:
This is a Class A‐UPS Product. In a domestic environment, this product may cause radio interference, in which case the user may be
WARNING
required to take additional measures.
Eaton, Powerware, ABM, BladeUPS, Power Xpert, PowerVision, Powerware Hot Sync, and X-Slot are registered trademarks and ConnectUPS is a
trademark of Eaton Corporation or its subsidiaries and affiliates. Greenlee is a registered trademark of Greenlee Textron. Modbus is a registered
trademark of Schneider Automation. National Electrical Code and NEC are registered trademarks of National Fire Protection Association, Inc.
Phillips is a registered trademark of Phillips Screw Company. All other trademarks are properties of their respective companies.
ECopyright 2007–2010 Eaton Corporation, Raleigh, NC, USA. All rights reserved. No part of this document may be reproduced in any way without
the express written approval of Eaton Corporation.