To Connect A Color Monitor; To Connect The Monitors To The Board - Planar DOME Md4/PCX Installation Manual

126

To connect a color monitor

Use this table to attach the cables to the appropriate
output signals on your color monitor.
Color Monitor Configuration
Cable Label

To connect the monitors to the board

1. Attach the D-shell connector to the Md4/PCX board,
securing the connection with the screws on the
connector.
2. Attach each of the output cables to the appropriate
BNC terminal on your monitor.
Refer to your monitor documentation for more infor-
mation about the connector assignments.
3. Repeat step 2 for each monitor that you want to connect
to the Md4/PCX board.
Output Signal
GREEN Green
RED Red
BLUE Blue
VSYNC Vertical sync
HSYNC Horizontal sync
Chapter 4