Table of Contents
Advertisement
Installing the Md4/PCX Board and Driver in a Sun PCI Workstation
MD4PCX_STEREO_SCREEN_POSITION variable
The
MD4PCX_STEREO_SCREEN_POSITION
variable controls which region of the framebuffer are visi-
ble when switching to stereo mode. It is useful only if pan-
ning and scrolling is not enabled.
This table describes the settings for aligning the screen with
the
MD4PCX_STEREO_SCREEN_POSITION
This
value...
0
1
2
3
4
5
6
7
Horizontally, the screen can be placed only at multiples of
128 pixels from
value to 400 (for example,
POSITION=7,400,25
The X property
actual position and size (
screen when the screen that switches to stereo mode.
MD4PCX_STEREO_SCREEN_POSITION Settings
Aligns the visible area to this position
while switching to stereo mode...
Top-left corner of the framebuffer
Top-center position of the framebuffer
Top-right corner of the framebuffer
Bottom-right corner of the framebuffer
Bottom-center position of the framebuffer
Bottom-left corner of the framebuffer
Center of the framebuffer
The supplied x, y value; for example,
MD4PCX_STEREO_SCREEN_POSITION=7,400,25.
Make sure there are no spaces in this variable
setting.
. That means that if you set the
x=0
MD4PCX_STEREO_SCREEN_
), the 400 snaps back to 384.
DOME_STEREO_GEOMETRY
x, y, w, h
environment
variable.
reports the
) of the initial stereo
89
Advertisement
Table of Contents
