Table of Contents
Advertisement
90
DOME_STEREO_GEOMETRY
however. It does not report placement after panning or
scrolling, if panning or scrolling is enabled.
To set the environment variables
1. Copy the file
/etc/dt/config/Xconfig
/etc/dt/config/Xconfig
2. Find the line in
contains
3. Remove the pound sign (
4. Add the environment variable.
These examples show how to set the environment
variables.
This example enables panning and scrolling:
Dtlogin*environment: MD4PCX_STEREO_PAN=3
This example sets a zone of 150 pixels at each corner of
the screen through which the cursor can pass out of the
visible area without causing panning or scrolling:
Dtlogin*environment: MD4PCX_STEREO_PAN=3 \
MD4PCX_STEREO_NO_PAN_ZONE=150
This example aligns the screen to the bottom-center
position of the framebuffer:
Dtlogin*environment: \
MD4PCX_STEREO_SCREEN_POSITION=4 \
MD4PCX_STEREO_PAN=2
reports only the initial placement,
/usr/dt/config/Xconfig
, and then edit
.
/etc/dt/config/Xconfig
Dtlogin*environment
) to uncomment that line.
#
Chapter 3
to
that
.
Advertisement
Table of Contents
