Table of Contents
Advertisement
Installing the Md4/PCX Board and Driver in a PC
To install multiple Md4/PCX boards
Repeat the installation instructions on page 15 for each
board.
Tips
Remember these tips when installing multiple boards:
• You can install as many Md4/PCX boards as your sys-
tem's power supply and available PCI slots can support.
• Each board requires less than 3 amps of +5V.
• The Windows NT driver (version 4.4.0 or later) supports
up to eight (8) Md4/PCX boards (16 screens).
• The Windows NT driver (versions 4.01–4.3.3) supports
up to four (4) Md4/PCX boards (eight (8) screens).
• You cannot mix DOME board types in one system; for
example, you cannot run one Md4/PCX boards and one
Md5/PCX™ board.
• If you are using multiple Md4/PCX boards, disable
VGA mode on each additional Md4/PCX board. See
"To disable VGA mode" on page 13.
17
Advertisement
Table of Contents
