Planar DOME Md4/PCX Installation Manual page 128

Planar md4/pcx display controllers: install guide
Table of Contents

Advertisement

114
After you enter all of the information for the first board,
board zero (0), the program begins again with this
prompt:
Please enter the number corresponding to the
type for DOME board #1:
7. Continue answering these questions for all DOME
boards in your system.
8. Type
you have finished entering information for all DOME
boards in your system.
This message appears:
Would you like to edit the driver config file
[y, n]?
9. Type
Do not edit the driver configuration file unless you
have extensive experience editing such files.
The installation rebuilds your kernel. It also saves your
old kernel to safeguard against potential problems. If
the new kernel does not boot, see "Resolving booting
problems with the new kernel" on page 115.
Make sure you know the kit name before you shut
down the system. See "Determining your kit name"
on page 111.
10. Unmount the diskette and remove it from the disk
drive by typing:
# unmount /mnt
11. Shut down your system with this command:
# shutdown -h now
(zero) at this prompt to exit the program when
0
.
n
Chapter 4

Advertisement

Table of Contents
loading

Table of Contents