Installing the Md4/PCX Board and Driver in a Digital UNIX Workstation
7. Attach the VGA ribbon cable to the Md4/PCX board.
(The connector is keyed to ensure it is plugged in
correctly.)
8. Install the Md4/PCX board in one of the 64-bit slots.
Follow the steps in "To install the board" on page 119.
To support VGA with another VGA board
When you use another board to support VGA display, you
must disable VGA mode on the Md4/PCX board. You
must also disable VGA on additional Md4/PCX boards if
you install more than one in your system. See "To disable
VGA mode" on page 123.
Attaching a VGA ribbon cable
121