Planar DOME Md4/PCX Installation Manual page 28

14
To enable VGA boot messages on a
high-resolution monitor
Use this table to set switch S1 to direct VGA boot messages
to a high-resolution monitor.
DIP Switch
The setting of DIP switch 3 on switch S1 determines
whether the Md4/PCX board can display boot messages
to a high-resolution monitor. The setting of DIP switch 2
on switch S1 determines whether VGA is enabled or
disabled.
Enabling VGA Mode Boot Messages
Position Note
1 OFF If OFF, the Md4/PCX board acts as
the VGA device. The output, however,
is directed to the high-resolution
screen instead of the VGA connector.
ON If ON, the Md4/PCX board copies the
text from the VGA device to the high-
resolution monitor.
2 ON Must be ON.
3 OFF Must be OFF. Lets you direct VGA
boot messages to the high-resolution
monitor.
4 ON Must be ON.
Chapter 2