Table of Contents
Advertisement
86
Installation of <DOMEmd4px> was successful.
Installation of <DOMEmdlib> was successful.
You do not need to reboot your system unless you did
not boot it with the
board. See page 78.
7. Set up your system for stereo display, if necessary, as
described in the next section.
If you are not using the Md4/PCX board to support
stereo display, see "Configuring Display Settings" on
page 91. For additional information about stereo
mode, refer to the Stereo Library Installation and Devel-
oper's Guide.
Setting up display for stereo mode
When you enable stereo mode, parts of the screen (on the
right and bottom) may be hidden if the stereo screen reso-
lution is smaller than the non-stereo resolution. If any
objects or icons are located on the right or bottom of your
screen before you enable stereo mode, they may become
invisible when you first enable stereo mode.
The driver software for the Md4/PCX board (version 1.2.1
or later) provides environment variables that enable pan-
ning and scrolling while in stereo mode. After you set these
variables, moving the cursor out of the visible area will
automatically cause previously hidden areas to pan or
scroll into the visible area.
option after you installed the
-r
Chapter 3
Advertisement
Table of Contents
