Table of Contents
Advertisement
10
To support VGA display with the Md4/PCX board
1. Remove the existing VGA board from your computer.
2. Enable VGA mode on the Md4/PCX board; follow the
instructions under "To enable VGA mode" on page 12.
3. Attach the VGA ribbon cable to the Md4/PCX board.
(The connector is keyed to ensure it is plugged in
correctly.)
4. Install the Md4/PCX board in your PC by following the
instructions on page 15.
Attaching a VGA ribbon cable
Chapter 2
Advertisement
Table of Contents
