16
3. Make sure the board connector pins are aligned with
the slot.
Installed
Md4/PCX board
4. Secure the mounting bracket with the bracket screw.
If you are not supporting VGA with the Md4/PCX
board, go to step 8.
5. Remove a blank bracket from the back of the slot you
choose for the VGA output.
6. Insert the VGA bracket and secure the mounting
bracket with the bracket screw.
7. Attach the VGA monitor to the 15-pin connector.
Repeat steps 1–4 for each Md4/PCX board you want
to install.
8. Replace the system unit cover.
Chapter 2