Installing the Md4/PCX Board and Driver in a Sun PCI Workstation
To set switch S1 to disable VGA mode
The Md4/PCX board cannot operate as a VGA board in
a Sun PCI workstation, so you must disable VGA on the
Md4/PCX board. To do so, slide the DIP switches on
switch S1 into the positions shown in this table.
DIP Switch Settings
to Disable VGA Mode
DIP Switch
Switch S2
The default settings for switch S2, located to the right of
switch S1, are all OFF. If you change the default settings,
switch S2 overrides the software settings for default
monitor mode. See "Using the Default Monitor Mode" on
page 92 for more information.
on Switch S1
Position
1
ON
2
ON
3
ON
4
ON
79