Removing The Left Control Panel - Dell PowerEdge R7615 Installation And Service Manual

Figure 213. Installing the right control panel
Next steps
1. Install the side wall bracket.
2. Install the cooling fan cage
3. Install the drive backplane
4. If removed, install the air
5. Follow the procedure listed in

Removing the left control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the drive backplane
4. If installed, remove the air
5. Remove the cooling fan cage
6. Remove the side wall
Steps
1. Using the Phillips #1 screwdriver, remove the screws that secure the left control panel and the cable cover to the system.
2. Remove the cable cover away from the system.
3. Disconnect the control panel cable from the connector on the system board.
4. Holding the cable, slide the left control panel out of the system.
NOTE: Observe the routing of the cable as you remove the right control panel from the system.
assembly.
cover.
shroud.
After working inside your
Safety
Before working inside your
cover.
shroud.
assembly.
bracket.
system.
instructions.
system.
Installing and removing system components 257