Side Wall Brackets; Removing The Side Wall Bracket - Dell PowerEdge R7615 Installation And Service Manual

Side wall brackets

Removing the side wall bracket

There are two side wall brackets on either side of the system. The procedure to remove is similar.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed, remove the air
4. Remove the cooling fan cage
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cables
properly when you replace them to prevent the cables from being pinched or crimped.
Steps
1. Press the blue side tabs to release the side wall cable holder.
NOTE: Move the cables out of the side wall cable holder.
2. Press the center tab to release the bracket from the chassis, and lift it away from the system.
Figure 69. Removing the side wall bracket
Next steps
1. Replace the side wall
Safety
Before working inside your
shroud.
assembly.
bracket.
instructions.
system.
Installing and removing system components 107