Steps
1. Align the connectors and guide slots on the rear mounting front PERC module with the connectors and guide pins on the
drive backplane.
2. Slide the rear mounting front PERC module until the module is connected to the drive backplane.
3. Using a Phillips #2 screwdriver, tighten the captive screws on the rear mounting front PERC module.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 99. Installing the rear mounting front PERC module
Next steps
1. Connect all the cables, observe the cable routing.
2.
Install the cooling fan cage
3. If removed,
install the air shroud
4.
Install the drive backplane
5. Follow the procedure listed in
Removing the front mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the cooling fan cage
4.
Remove the drive backplane
5. If required,
remove the air shroud
6. If required,
remove the drive backplane
7. Disconnect all the cables, observe the cable routing.
NOTE:
Refer
Cable routing
assembly.
or
install the GPU air
cover.
After working inside your
Safety
instructions.
Before working inside your
assembly.
cover.
or
remove the GPU air
cover.
topic for more information.
shroud.
system.
system.
shroud..
Installing and removing system components
137