Initializing Tpm For Users; Initializing The Tpm 1.2 For Users; Initializing The Tpm 2.0 For Users; Control Panel - Dell VCG3C Assembly, Installation And Service Manual

Initializing TPM for users

Steps
1. Initialize the TPM.
For more information, see
2. The TPM Status changes to Enabled, Activated.

Initializing the TPM 1.2 for users

Steps
1. While booting your system, press F2 to enter System Setup.
2. On the System Setup Main Menu screen, click System BIOS > System Security Settings.
3. From the TPM Security option, select On with Preboot Measurements.
4. From the TPM Command option, select Activate.
5. Save the settings.
6. Restart your system.

Initializing the TPM 2.0 for users

Steps
1. While booting your system, press F2 to enter System Setup.
2. On the System Setup Main Menu screen, click System BIOS > System Security Settings.
3. From the TPM Security option, select On.
4. Save the settings.
5. Restart your system.

Control panel

This is a service technician replaceable part only.

Removing the left control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the front bezel.
4. Remove the air shroud.
Steps
1. Disconnect the control panel cable from the system board connector.
NOTE: Observe the routing of the cable as you remove it from the system.
2. Using the Phillips #1 screwdriver, remove the screws that secure the left control panel assembly to the system.
3. Hold the left control panel assembly and remove the control panel along with the cable from the system.
78 Installing and removing system components
Initializing the TPM for users.
Safety instructions.
Before working inside your system.