Table of Contents
Advertisement
Figure 76. 12 x 3.5 inch SAS/SATA with APERC12 in Riser 2 and Rear 4 x 2.5 inch SAS/SATA
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 71. 12 x 3.5 inch SAS/SATA with APERC12 in Riser 2 and Rear 4 x 2.5 inch SAS/SATA
Order
1
2
3
4
114
Installing and removing system components
From
SIG_PWR_0 (system board power
connector)
CTRL_SRC_SA1 (fPERC controller
connector)
CTRL_SRC_SB1 (fPERC controller
connector)
SIG_PWR_1 (system board power
connector)
To
BP_PWR_1 (backplane power
connector)
BP_DST_SA1 (backplane expander signal
connector)
BP_DST_SA1 and BP_DST_SB1
(backplane expander signal connector)
BP_PWR_1 (backplane power
connector)
Advertisement
Table of Contents
