Installing the 4 x 2.5-inch rear drive module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. If required,
remove the air
4.
Remove the
drives.
5. If installed,
remove the BOSS-N1
6. Disconnect the cables from the rear drive module.
NOTE:
Refer
Cable routing
Steps
1. Align and lower the rear drive module with the guide on the system.
2. Using a Phillips #2 screwdriver, tighten the captive screws that secure the rear drive module into the system.
Figure 58. Installing the 4 x 2.5-inch rear drive module
Next steps
1. Connect and route all the cables to the rear drive module.
2.
Install the
drives.
3. If removed,
install the BOSS-N1
4. If removed,
install the air
5. Follow the procedure listed in
Safety
instructions.
Before working inside your
shroud.
module.
topic for more information.
module.
shroud.
After working inside your
system.
system.
Installing and removing system components
101