Installing the side wall bracket
There are two side wall brackets on either side of the system. The procedure to install is similar.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed,
remove the air
4.
Remove the cooling fan cage
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cables
properly when you replace them to prevent the cables from being pinched or crimped.
Steps
1. Align the guide slots on the side wall bracket with the guides on the system and slide until the cover is seated firmly.
NOTE:
Route the cables through the side wall cable holder.
2. Close the side wall cable holder until the holder clicks into place.
Figure 70. Installing the side wall bracket
Next steps
1.
Replace the cooling fan cage
2. If removed,
install the air
3. Follow the procedure listed in the
108
Installing and removing system components
Safety
instructions.
Before working inside your
shroud.
assembly.
assembly.
shroud.
After working inside your
system.
system.