Figure 56. Installing the 2 x 2.5-inch rear drive module
Next steps
1. Connect and route all the cables to the rear drive module.
2.
Install the
drives.
3. If removed,
install the air
4. Follow the procedure listed in
Removing the 4 x 2.5-inch rear drive module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. If required,
remove the air
4.
Remove the
drives.
5.
NOTE:
If BOSS-N1 module is installed, ensure to disconnect the BOSS-N1 power cable and Signal cable before removing
the 4 x 2.5-inch rear drive module.
shroud.
After working inside your
Safety
instructions.
Before working inside your
shroud.
system.
system.
Installing and removing system components
99